Front License Plate Bracket Holder for Ford Focus ST 2013–2018 Black

The entire bracket can be assembled using two M3 screws and self locking nuts. I used four M3 washers as well.
To mount your license plate you will need self tapping screws that are no longer than 2cm and .5cm diameter (including the thread).
The bottom left cylindrical dome will make contact with the body of your vehicle, to prevent scratching I domed the end, but I recommend placing some rubber or felt end on it just to be safe. I used the rubber end of a cane I found at ACE, but can also be found on amazon (or ebay!)
This fit nicely and I secured it with a bit of glue.

Place the Grill Plug in the grill hole indicated in the photos and use two Grill Hooks on the top and the bottom to reach around and secure the plug in place.
Insert the connecting rod into the Grill Plug so the screw holes line up. If you are confused which way make sure the end that is flat passes through the Grill Plug.
Use one M3 screw along with two M3 washers to secure all four pieces together. You may find it easier to pass the screw through the bottom opposed to the top. Use a M3 self locking nut to secure it.
Mount your license plate to the License Mount using self tapping screws, and place your rubber or felt tip of choice on the appropriate corner.
Slide the License Mount on to the connecting rod and secure it with one M3 screw, two M3 washers, and a M3 self locking nut.

Just to be safe I attached a zip tie through the grill and anchored it directly to the License Mount. This is just an extra precaution in case the Connecting Rod snaps, that way I won't lose the License Plate and have to wait in line at the DMV to get new ones.

Extra connecting rods are included in the order, in case they snap (They won't break during driving, but because this is 3d printed, it can still be broken by running into it or otherwise being rough with it)