2x Door Speaker Adapters for Toyota GT86/Scion FR-S/Subaru Fits Andrian A165V/G

This is a Door Speaker Adapter for Toyota GT86/Scion FR-S/Subaru BRZ. It is a full redisign of Schankenstein´s Speaker Adapter. It also features a rainshield, which is allways very important to have. It is made for the Andrian Audio A165V and A165G speakers

Note:

-Even if the position of the door speaker is less critical in case of the FT86 compared to other cars, there is still a risk to guide water, dripping down from the window slot, into the interior of the car when installing aftermarket speakers. Most OEM speakers include a rainshield, but this is often erased when aftermarket speakers are installed.

Installation:

-drill hole(s) for speaker cable as necessary, drill in upper section to avoid water getting to the inside
-install speaker in a clocking where terminal is NOT pointing downward! best position is terminal pointing to rear end of car.
-keep speaker cable long enough to that it generates a downward pointing ellbow inside of the door, this is important to make sure that any water drops flowing down the cable drip of at the lowest point of the ellbow, so no water comes to the speaker/terminal and from there down the chasis and maybe to the interior
-use butyl rope to seal the gab between adapter and door metal, usually this butyl rope is 10mm thick, thats to much, stretch it so hat it has a diameter of about 5mm and apply it the backside of the adapter
-heat up the door metal directly before application of the prepared adapter with a hot air gun, butyl has a much better adhesion and is easier to form when its a little hot; little more then hand warm is enough
-press down adapter firmly before tightening the screws until it touches the plastic threaded rivets which was also used for the OEM speaker
-use the OEM screws for fixing the adapter finally, thru holes should be drilled manually to a diameter of 6,5 or 7mm (they are intentionally slightly too small in the model)
-install the speaker, remember to form an elbow in the cable

This item will be printed in BLACK unless otherwise requested

PROUDLY MADE IN THE USA!

How is it made?

This item is made from 100% solid PETG which is FDM 3D-Printed to order on commercial Machines! These parts are guaranteed to be acceptable strength for the application.

How is it shipped?

USPS! Shipping is free for you if you're located in the continental United States!

PLEASE NOTE: We have up to a 5 day handling time to allow us time to print your item - Do not fear! Your item is on time and you have not been forgotten, We just aren't a typical ebay business that can ship out orders the next day..

I think there’s a problem with my order?

No worries, we have you covered! If you have any issues whatsoever, please contact us! Your satisfaction is of the utmost importance to us, and most issues with part quality or shipping can be resolved via a quick message to us!! (Just please allow us 1-2 business days to respond 🙂)

What else do you offer?

We offer a wide variety of 3d print services such as design and print on demand in a variety of materials at a fair price. Simply send us a message to get started designing or printing your custom part today for any project you need and check out our profile for our other items!

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Designed by:TRS84 Source:thing:2821953