How is it made?

This item is made from 100% solid PETG which is FDM 3D-Printed on commercial Machines! These parts are guaranteed to be acceptable strength for the application.

How is it shipped?

USPS! Shipping is free for you if you're located in the continental United States!

I think there’s a problem with my order?

No worries, we have you covered! If you have any issues whatsoever, please contact us!

What else do you offer?

We offer a wide variety of 3d print services such as design and print on demand in a variety of materials at a fair price. Simply send us a message to get started designing or printing your custom part today for any project you need and check out our profile for our other items!

Instructions

**THIS PROCESS WILL DIFFER DEPENDING ON YOUR CHASSIS**

Step 1: Remove the accelerator pedal by removing the c-clip or pushing in the pin on the back right side of the pedal followed by the bottom clip behind the pedal.

Step 2: Remove the throttle cable from the bracket

Step 3: Locate and remove the accelerator pedal pivot bracket clip holding it in place, this will allow you to remove the assembly

Step 4: Remove the old worn out bushings

Step 5: Grab the bolt and one washer from the provided press tool. Put the washer on the bolt followed by one of the bushings with the flat side towards the washer.

Step 6: Place the cup from the press tool over the lip, if your vehicle does not have the lip it will be on the outside. The inside referring to the middle of the accelerator bracket.

Step 7: Take the bolt with the washer and bushing and insert it from the opposite side of the cup and place the other washer and nut and hand tighten it.

Step 8: Hold one end and tighten the other side and the bushing will start to press in.